Race V2 VTX
The HDZero Race VTX is a digital HD video transmitter capable of delivering up to 200mW on 5.8GHz. It supports all the HDZero cameras with MIPI connector, including Nano90.
The power input range is 7V – 17V.
| 1 | Power In (G=Ground, V=7-17V) |
| 2 | T1/R1 UART Connection to FC |
| 3 | T2, Reserved, R2/SA, SA Pin |
| 4 | u.FL Antenna Connector |
| 5 | u.FL Antenna Retention Holes |
| 6 | MIPI connector |
| 7 | MIPI connector retention Holes |
| 8 | Firmware Update Connector |
| 9 | Power on LED (red) |
| 10 | Status LED (blue) |
| 11 | u.FL Antenna Retention Screws/Nut/Plate |
| 12 | Rubber Grommet (M4 to M3), 1mm O-Ring |
| 13 | Zip ties |
| 14 | Connecting wire |
| 15 | 20x20 M4 mounting holes |
Mounting a u.FL antenna or pigtail
There are 2 methods to mount the antenna on VTX:
Use included retention screws, nuts and plate;
Use included zip-ties.
Connecting MIPI cable
Use the included zip-tie to secure MIPI cable and protect MIPI connector.
TIP
Notes:
Read first: General Consideration for VTX Installation
Make sure to use a wider top plate to fully cover this VTX for protection.
Eason FPV
czhou1972